The first QX-Core render was technically fine and still looked wrong. The feedback was blunt: the cables look like spider legs, and when the shell opens the parts look scattered. Both problems are about how the eye reads structure, not about rendering.
Cables: thin, few, and out of the silhouette
- Radius 4.8 mm → 1.9 mm. At product scale a thick cable has the visual weight of a limb.
- Six → four. Six strands spread evenly around a body is exactly the pattern people read as legs.
- Route them behind. Cables now leave rear ports and drop to rear glands, so from the hero angle they barely cross the silhouette.
HOUDINI: MESH THE VELLUM CURVES
pwire = sop.createNode("polywire", "mesh_cables")
pwire.setInput(0, vellum_solver)
pwire.parm("radius").set(0.0019) # metres: 1.9 mm
pwire.parm("div").set(14) # round enough for close-ups
pwire.parm("segs").set(2)
pwire.parm("smooth").set(1)
nrm = sop.createNode("normal", "cable_normals")
nrm.setInput(0, pwire)
nrm.parm("cuspangle").set(60.0)Panels: every moving part needs something to move on
- Add the structure. A fixed core cage (front and rear bands, four spars, a bezel ring) stays put, so the opened state still has a body.
- Show the rails. Each panel slides on two guide rails fixed to that cage. The eye sees why the part is where it is.
- Move straight and short. One axis per panel, no flaring or tumbling, travel cut from 40 mm to 30 mm.
- Delete what is not attached. Loose rods, floating sockets and decorative iris blades were removed. If you cannot say what holds a part, the viewer cannot either.
The testPause on the most open frame. If you can trace a physical path from every part back to the base, the reveal reads as engineering. If not, it reads as an explosion.